Chapter 18 System Setup (System)
1076
System Settings (System Config Menu)
Notes
• Make sure that [Tally Master] is set to On.
• When simple connection is used between the center control panel and remote
panel (see page 1305), this setting is disabled.
Specifying the DME Connected to the Switcher
1
In the System >System Config menu, press [Switcher Assign].
The Switcher Assign menu appears.
2
Using either of the following methods, select the switcher to which the
settings apply.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
The selected switcher appears in reverse video.
3
Make the DME settings as follows.
• When making DME settings for SWR1, for the first DME, select
[DME1] in the <1st DME> group. For the second DME, select [DME2]
in the <2nd DME> group. When a second DME is not connected, turn
all buttons in the <2nd DME> group off.
• When making DME settings for SWR2, for the first DME, select
[DME3] in the <1st DME> group. For the second DME, select [DME4]
in the <2nd DME> group. When a second DME is not connected, turn
all buttons in the <2nd DME> group off.
Enabling the FM Data Port of the Switcher
With the FM data port enabled, frame memory data can be transferred in a short
time between the switcher and the control panels.
Notes
If multiple control panels are in use, [FM Data Port Enbl] can be turned on for
only one control panel per switcher.
1
In the System >System Config menu, press [Switcher Assign].
The Switcher Assign menu appears.
2
Using any of the following methods, select the switcher to be set.
To Next Page
Loading...
