Sony MVS-8000 - Making a Setting for Linking Two M;E Banks

Chapter 20 Switcher Setup (Switcher)
1239
Settings Relating to Function Links (Link Menu)
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
7 In the <Bus> group, select any of the following.
Enable: Enable the GPI link setting for the selected bus.
Disable: Disable the GPI link setting for the selected bus.
All Enable: Enable the GPI link setting for all buses.
Setting the delay value
1 In the Switcher >Link >GPI Link Adjust menu, turn the knobs to select the
output port for which you want to set the delay value, and the
corresponding delay value.
2 Press [Delay Set].
This confirms the delay value, which is reflected in the status area.
Making a Setting for Linking Two M/E Banks
You can link any two M/E banks for some operations by using the Switcher
>Link >M/E Link menu.
The operations for which you can link two M/E banks are as follows.
• Transition execution (auto transition, cut, and fader lever operation)
• Next transition selection
• Transition type selection
Notes
Clip transition execution is excluded from the above transition execution
operations.
1 In the Switcher >Link menu, press [M/E Link].
Knob Parameter Adjustment Setting values
4 Bus Bus selection 1 to 114
Knob Parameter Adjustment Setting values
1 GPI Port GPI output port for the
setting
1 to 8
5 Delay Delay value for the output
port
0 to 300 (fields)