Chapter 22 DCU Setup (DCU)
1097
Serial Port Settings (Serial Port Assign Menu)
9. Status Sense Interval: time until the next Status Sense command is issued (Simple
VDCP Setting menu only)
9
Turn the knob to set the disk recorder video port number or response speed.
When setting the video port number
a) 0: No assignment
When setting the response speed
10
Press [Set].
This confirms the setting.
11
If required, repeat steps 4 to 10, to set other items.
To enable or disable the loop and recue functions
Press the [Loop] and [Recue] buttons, respectively.
Loop: Replay the recalled file in a continuous loop.
Recue: After playing the recalled file, recue to the beginning and then stop.
Making detailed settings for an Extended VTR
1
In the DCU >Serial Port Assign menu, select the setting target (DCU1 or
DCU2) from the <DCU Select> group.
2
Using any of the following methods, select the serial port connected to the
Extended VTR for which you want to make the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) The range of setting values depends on the DCU port setting. (When the MKS-2700 is
connected, select 2 for the slot and a value in the range 1 to 6 for the port.)
3
Press [Port Setting].
The DCU >Serial Port Assign >Extended VTR Setting menu appears.
Knob Parameter Adjustment Setting values
2 Setting Video port number
0 to 127
a)
Knob Parameter Adjustment Setting values
2 Setting Response speed 0 to 255
Knob Parameter Adjustment Setting values
1 Port No Serial port number
1 and upwards
a)
To Next Page
Loading...
