Chapter 3 Signal Selection and Transitions
153
Independent Key Transitions
2
With the numeric keypad, enter the transition rate.
• Enter a value of up to three digits.
• To clear the entry value, press the [CLR] button.
For details of frame input mode and timecode input mode, see page 135.
3
Press the [ENTER] button.
This confirms the entry, and the selected region name and the set transition
rate appear in the numeric keypad control block display.
To enter a difference from the current value
After pressing the [+/–] button, enter the difference and press the [TRIM]
button.
To change the sign (+ or –), press the [+/–] button.
Setting the independent key transition rate by a menu operation
1
In the M/E or PGM/PST menu, select first the desired one from VF1
‘Key1’ to VF4 ‘Key4,’ then HF6 ‘Transition.’
The Transition menu for the selected key appears.
2
Select any transition type in the <Transition Type> group.
If, in the Setup menus, you set insertion/deletion as independent modes,
make the settings for insertion in the <On Transition Type> group, and the
settings for deletion in the <Off Transition Type> group.
3
Turn the knob to set the transition rate.
Displaying the independent key transition rates in a menu and
changing the settings
For each of the M/E and PGM/PST banks, you can also display the transition
rate and independent key transition rate, and change the settings.
For more details, see “Displaying a List of Transition Rates and Changing the
Settings” (page 361).
Knob Parameter Adjustment Setting values
1 Transition Rate Transition rate 0 to 999 (frame count)
To Next Page
Loading...
