Chapter 4 Keys
165
Key Setting Operations Using Menus
When clean mode is enabled, key fill is added to the background
without cutting out with key source.
When chroma key is selected: Select [Chroma Adjust] to access the
Chroma Adjust menu (see page 170), and make the required settings.
When a wipe pattern key is selected: In the M/E-1 >Wipe menu (see
page 229), select the pattern and set any modifiers, then return to the
M/E-1 >Key1 menu.
When a key wipe pattern key is selected: In the M/E-1 >Key1 >
Transition >Wipe Adjust menu (see page 254), carry out pattern
selection and modifier setting, then return to the M/E-1 >Key1 >Type
menu.
Notes
For a wipe pattern selected for a wipe pattern key or key wipe pattern key,
the [Edge] and [Direction] modifier settings are not available.
4
Set the parameters.
• When a luminance key or linear key is selected
a) Setting this value to 1, produces the “through” state in which no filter is applied. The larger
the value, the more strongly the filter applies.
• When a chroma key is selected
• When a color vector key is selected
Knob Parameter Adjustment Setting values
1 Clip Reference level for generating the
key signal
+109.59 to –7.31
2 Gain Key sensitivity –100.00 to +100.00
3 Density Key density 0.00 to 100.00
4 Filter Filter coefficient
1 to 9
a)
Knob Parameter Adjustment Setting values
3 Density Key density 0.00 to 100.00
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 Y Clip Reference level for creating
luminance signal
+109.59 to –7.31
2 Y Gain Luminance signal sensitivity –100.00 to +100.00
3 C Clip Reference level for creating
chrominance signal
100.00 to 0.00
4 C Gain Chrominance signal sensitivity –100.00 to +100.00
To Next Page
Loading...
