Chapter 4 Keys
181
Key Setting Operations Using Menus
When the edge type is outline, in place of the edge fill signal, the selected
key fill signal fills the outline, and elsewhere remains as the background.
5
Carry out the following operation, depending on the selection in step 4.
When [Utility 1 Bus] is selected: Press the key delegation button
[UTIL1], turning it on, and select the signal in the key row.
When [Matte] is selected: Press [Matte Adjust] in the same EDGE menu,
to display the Matte Adjust menu, and adjust a single color or two-
color combination color matte.
You can select whether to use a single color matte or a two-color
combination color matte in the <Edge Matte> group.
For the color mix operation, see “Carrying out a color mix for the key edge
fill matte” (page 182).
6
When emboss is selected for the edge type, adjust the color in the <Emboss
Fill> group.
To adjust matte 1 press [Matte1], and to adjust matte 2 press [Matte2], then
adjust the following parameters.
7
To make the edge soft, press [Soft Edge] to set it on, and adjust the
softness.
For a normal edge, when [Soft Edge] is enabled, [Key Drop] is kept on.
8
To make separate fine adjustments to the positions of the left, right, top,
and bottom of the source edge, press [Fine Key], to set it on, and adjust the
following parameters.
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
Knob Parameter Adjustment Setting values
1 Soft Edge softness 0.00 to 100.00
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 Top Key top edge position –2.00 to +2.00
2 Left Key left edge position –2.00 to +2.00
3 Right Key right edge position –2.00 to +2.00
To Next Page
Loading...
