Chapter 5 Wipes
245
Basic Procedure for Wipe Settings
Magnitude
Through the course of the transition the wipe pattern rotates through the
specified angle.
The parameter Angle determines an angle of pattern inclination at the
beginning of the transition.
• A value of –100.00 corresponds to the angle rotated one whole turn
counterclockwise.
• A value of +100.00 corresponds to the angle rotated one whole turn
clockwise.
• With a value of 0.00 the pattern is stationary.
The parameter Magnitude determines an angle of pattern rotation through the
course of the transition.
• A value of –200.00 corresponds to a rotation of two turns counterclockwise.
• A value of +200.00 corresponds to a rotation of two turns clockwise.
• With a value of 0.00 the pattern is stationary.
You can apply rotation independently to the main pattern and sub pattern.
1
In the M/E-1 >Wipe menu, select HF5 ‘Main Modify.’
The Main Modify menu appears.
2
In the <Rotation> group, select the rotation type.
Angle: Incline the pattern through a fixed angle.
Speed: Rotate at a fixed rate.
Magnitude: Rotate through a particular angle during the course of the
transition.
3
According to the selection in step 2, set the following parameters.
• When Angle is selected
Knob Parameter Adjustment Setting values
1 Angle Angle of pattern rotation –100.00 to +100.00
To Next Page
Loading...
