Chapter 10 Special Functions
402
Multi Program 2
1
In the status area of the Engineering Setup >Panel >Config >MP2 Main/
Sub Assign menu, select 1st Row (M/E-1), then press [Main] in the <Main/
Sub Assign> group.
2
Press [Dual M/E Assign] to assign M/E to two banks.
In this state, both 1st Row and 2nd Row are set to main.
3
Set 2nd Row to [Sub].
This cancels the shift/non-shift assignment for dual M/E in standard mode.
Notes
It is not possible to assign the combinations of Main with Main&Sub, or Sub
with Main&Sub.
Assigning the [MAIN] and [SUB] delegation buttons to buttons
on the control panel
1
In the Engineering Setup >Panel >Config menu, press [Program Button].
The Program Button menu appears.
2
Press [Transition Module 1].
The Transition Module 1 menu appears.
3
Select the switcher bank in the <Bank Select> group.
The buttons in the transition control block on the left appear in the
currently assigned state.
4
Press the button whose assignment you wish to change.
The button you press appears in reverse video.
5
From the list on the right, select [MAIN], and press [Set].
The indication on the button changes according to the selection.
6
Repeat Step 4 and 5 to assign [SUB].
To Next Page
Loading...
