Chapter 10 Special Functions
404
Multi Program 2
For details, see “Cross-Point Settings (Xpt Assign Menu)” in Chapter 19
(Volume 3).
Enabling DME wipe operations for sub
By factory default, DME wipe operations are inhibited for sub background. To
enable them, in the Engineering Setup >Switcher >Config menu, set [DME
Wipe Sub Enable] to On.
This enables DME wipe operations for sub background.
This setting applies to the whole control panel (all M/E banks and PGM/PST
bank).
Notes
If a DME wipe for sub is recalled in a snapshot or keyframe, the image will not
be handled correctly.
Inhibiting utility 2 bus signal selection
In Multi Program 2 mode, you can inhibit other uses of the utility 2 bus signal
in order to use the signal as the background for sub.
This setting applies to the whole control panel (all M/E banks and PGM/PST
bank).
In the Engineering Setup >Panel >Config >MP2 Main/Sub Assign menu, set
[Util2 Inhibit] to On.
This prevents the key row delegation button [UTIL2] from lighting.
Inhibiting key operations for main or sub keyer
In the Engineering Setup >Panel >Config >Operation Inhibit >M/E Operation
Inhibit menu, you can make settings to inhibit key operations on each of the
main and sub keyers independently.
For details, see “Inhibiting Utility 2 Bus and Key Operations” in Chapter 19
(Volume 3).
Including Multi Program 2 data in recall operations of keyframes
and snapshots
In the Engineering Setup >Switcher >Config menu, set [Recall M/E Config] to
On.
When a keyframe or snapshot is stored or recalled, the following data is
included.
M/E Config, PGM Config, M/E Output Assign, and Key PVW Config
To Next Page
Loading...
