Chapter 11 DME Operations
523
DME Special Effect Operations
a) The Soft parameter is valid only when [Internal] is selected in the <Flex Shadow Source>
group.
• 16:9 mode
a) The Soft parameter is valid only when [Internal] is selected in the <Flex Shadow Source>
group.
4
In the <Flex Shadow Source> group, select the signal to use for the flex
shadow.
External: Generate the shadow using an input signal.
Internal: Generate the shadow using a full-size key signal.
5
In the <Flex Shadow Fill> group, select the signal to insert in the flex
shadow.
Flat Color: single color
Mix Color: mix color signal set in the Color Mix menu (see page 533)
Ext Video: an external video signal input to the Ext IN connector
6
Only if Flat Color is selected in step 5, adjust the following parameters.
Adjusting the size of the flex shadow
1
In the Flex Shadow menu, press [Size], turning it on.
4
Soft
a)
Softness of shadow 0.00 to 100.00
5 Density Density of shadow 0.00 to 100.00
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 H Move shadow horizontally –8.00 to +8.00 (SD)
–32.00 to +32.00 (HD)
2 V Move shadow vertically –4.50 to +4.50 (SD)
–18.00 to +18.00 (HD)
3 Size All Enlarge or shrink horizontally and
vertically
Value of Size H (see
page 524) shown
4
Soft
a)
Softness of shadow 0.00 to 100.00
5 Density Density of shadow 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
To Next Page
Loading...
