Chapter 11 DME Operations
531
DME Special Effect Operations
a) When set to a negative value, the image is stretched vertically, to become taller.
When set to a positive value, the image is stretched horizontally, to become wider.
Rotating the wipe crop pattern (Rotation)
1
In the <Rotation> group of the Wipe Crop menu, select one of the
following.
Angle: Incline the pattern through a fixed angle.
Speed: Rotate the pattern at a fixed speed.
2
Depending on the selection in step 1, set the following parameter.
• When Angle is selected
a) –1.00 represents a whole turn counterclockwise, and +1.00 represents a whole turn
clockwise. 0.00 is the original state.
• When Speed is selected
a) –100.00 represents a speed of four whole turns counterclockwise per second, and +100.00
represents a speed of four whole turns clockwise per second. 0.00 is the stationary state.
Applying modulation to the wipe crop pattern (Modulation)
1
In the <Modulation> group of the Wipe Crop menu, select one of the
following.
H (horizontal modulation): Modulate the pattern to apply waving in the
horizontal direction.
V (vertical modulation): Modulate the pattern to apply waving in the
vertical direction.
2
Set the following parameters.
Knob Parameter Adjustment Setting values
1 Aspect Aspect ratio
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Angle Angle of pattern rotation
–8.00 to +8.00
a)
Knob Parameter Adjustment Setting values
1 Speed Rotation rate of pattern
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Amplitude Amplitude of modulation 0.00 to 100.00
To Next Page
Loading...
