Chapter 2 Menus and Control Panel
58
Names and Functions of Parts of the Control Panel
a EDIT ENBL (edit enable) button
Press this button, turning it on, to enable
effect editing operations with the keyframe
control block.
When macro editing is carried out, this
button lights red.
b Edit point specification buttons
GO TO KF/TC (Go to keyframe/
timecode): Press this button, turning it
on, to enter a numeric value from the
numeric keypad control block, and
move the edit point to the specified
keyframe.
To move the edit point to the specified
timecode position, hold down the
[SHIFT] button in the device control
block, then press this button, turning it
on, and enter the desired numeric value
from the numeric keypad control block.
During macro editing, pressing this
button moves the edit point to the event
number specified by numeric entry
with the numeric keypad control block.
PREV KF (previous keyframe): When
this button is pressed, the edit point
moves to the keyframe immediately
before the current time (the position
where the effect is currently stopped).
0 EFF LOOP button
1 EDIT ENBL button
2 Edit point specification buttons
3 Editing buttons
4 Duration setting buttons
5 KF LOOP button
6 PAUSE button
7 Effect execution section
8 Effect execution direction selection buttons
9 STOP NEXT KF button
qa RUN CTRL button
To Next Page
Loading...
