Chapter 11 DME Operations
580
DME Special Effect Operations
a) Setting for SD 4:3, SD 16:9
b) Setting for HD 4:3, HD 16:9
Melt settings
You can set the degree of transition, the degree of extension in the image, the
jaggedness of the melting sections, and the amplitude, frequency, amount of
movement, and speed of the melting sections. You can also set the slant of the
borders, the shape of the sections that begin to melt, and other parameters.
To apply the Melt effect
With the Melt menu displayed, use the following procedure.
1
In the <Direction> group, select the direction in which the image melts
away.
Up: Melting occurs upward.
Down: Melting occurs downward.
2
To make transition settings, press [Transition] and set the following
parameters.
3
To make wave settings for melting part, press [Border] and set the
following parameters.
Knob Parameter Adjustment Setting values
1 H Horizontal center position of swirl
–8.000 to +8.000
a)
–32.000 to +32.000
b)
2 V Vertical center position of swirl
–6.000 to +6.000
a)
–18.000 to +18.000
b)
Knob Parameter Adjustment Setting values
1 Transition Degree of transition 0.00 to 100.00
2 Curve Degree to which image stretches 0.00 to 100.00
3 Random Degree of jaggies at melted part 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Amp Amplitude of waves 0.00 to 100.00
2 Freq Frequency of waves 0.00 to 100.00
3
Offset
a)
Amount of wave phase offset
–16.000 to +16.000
c)
–64.000 to +64.000
d)
4
Speed
b)
Direction and speed of waves –100.00 to +100.00
5 Slant Slant of border –100.00 to +100.00
To Next Page
Loading...
