Chapter 11 DME Operations
586
DME Special Effect Operations
Notes
The function for setting the bar mode of the lighting area is not supported on
the MVE-8000A.
Applying the Lighting effect
1
In the DME menu, select VF5 ‘Light/Trail’ and HF1 ‘Lighting.’
The Lighting menu appears.
2
Press [Lighting], turning it on.
The Lighting effect is enabled.
3
In the <Light Pattern> group, select the lighting pattern Plane, Bar or
Preset.
You can adjust the intensity of the light and other parameters with the
knobs.
4
Set the parameters.
The parameters differ as follows, depending on the selected lighting
pattern.
• When Plane is selected
a) You can make the Lighting effect more effective by adjusting [Total Ambient] to lower the
brightness of the entire image. This setting is used both by this effect and by the
Spotlighting effect.
Notes
The Total Ambient parameter is not supported on the MVE-8000A.
• When Bar is selected
a) You can make the Lighting effect more effective by adjusting [Total Ambient] to lower the
brightness of the entire image. This setting is used both by this effect and by the
Spotlighting effect.
Knob Parameter Adjustment Setting values
1 Light Intensity of light in highlight area 0.00 to 100.00
5 Total Ambient Brightness of whole image
0.00 to 100.00
a)
Knob Parameter Adjustment Setting values
1 Light Intensity of light in highlight area 0.00 to 100.00
2 Ambient Intensity of light in ambient area 0.00 to 100.00
5 Total Ambient Brightness of whole image
0.00 to 100.00
a)
To Next Page
Loading...
