Chapter 11 DME Operations
600
DME Special Effect Operations
2
Press [Wind], turning it on.
This enables the wind, and you can now adjust the parameters with the
knobs.
3
Set the following parameters.
a) 0.00 represents no afterimage, and 100.00 represents no decay in the afterimage.
4
To erase the afterimages, press [Wind Eraser], turning it on.
Selecting the signal for the afterimage portion
In the <Wind Source> group, select the image to fill the afterimage portion.
Notes
• “Mix Color” or “Ext Video” can only be applied to one of the background
(see page 619), flex shadow (see page 522), trail (see page 591), and wind
effects.
If you select “Mix Color” or “Ext Video” in the wind settings, a selection of
“Mix Color” or “Ext Video” in any of the other effects is disabled, and “Flat
Color” is selected in its place.
• When executing combining four channels of DME images, “Mix Color” and
“Ext Video” cannot be selected.
Freeze Video: Freeze the input image to use as the afterimage.
Flat Color: Use a single color matte for the afterimage; you can set the
following parameters with the knobs.
Hue Rotate: Use a single color matte with the hue changing for each frame as
the afterimage; you can set the following parameters with the knobs.
Knob Parameter Adjustment Setting values
1 Decay Amount of afterimage
displayed
0.00 to 100.00
a)
2 Shift H Extension in the horizontal
direction
–100.00 to +100.00
3 Shift V Extension in the vertical
direction
–100.00 to +100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
To Next Page
Loading...
