Chapter 11 DME Operations
608
DME Special Effect Operations
Keyframe trajectory
Setting the surface where light strikes the image
1
In the DME menu, select VF5 ‘Light/Trail’ and HF6 ‘Spot Lighting.’
The Spot Lighting menu appears.
2
Press [Spot Lighting], turning it on.
This enables Spotlighting, and you can now use the knobs to adjust the
parameters.
3
Set the following parameter.
• Lowering the brightness of the image makes Spotlighting more
effective.
• The Total Ambient setting is shared with the Lighting function.
4
In the <Surface Select> group, select the state of the surface struck by the
light.
Flat: The image surface is unchanged, causing the selected light source to
appear as the effect.
Texture: A texture appears on the surface of the image.
Non Linear: The Spotlighting effect is applied to an area to which a DME
nonlinear effect is applied.
KF2 = 1.12
KF2 = 0.12
KF1 = 0.88
Test sphere
Knob Parameter Adjustment Setting values
1 Total Ambient Brightness of whole image 0.00 to 100.00
To Next Page
Loading...
