Chapter 11 DME Operations
614
DME Special Effect Operations
b) Minus moves down, plus moves up.
c) Minus moves forward, plus moves deeper.
d) Minus moves counterclockwise, plus moves clockwise.
6
In the <Axis Select> group, select the coordinate space in which to place
the light source.
Source: Place the light source in the source coordinate space. The
spotlight moves when the image moves.
Target: Place the light source in the target coordinate space. The spotlight
does not move, even when the image moves.
For details of the coordinate space in which to place the light source, see
“Linking and unlinking image and spotlight” (page 604).
To set a test sphere
1
In the Light 1 menu, press [Test Sphere], turning it on.
A test sphere effect appears on the surface of the image.
2
Adjust the following parameter.
a) Light appears from Z direction. At –100.00 the light goes deepest, at +100.00 the whole
image is lit like a flat effect.
To select the lighted area
In the <Area Select> group, select one of the following.
FRGD: The light strikes the image foreground.
BKGD: The light strikes the image background.
Both: The light strikes both foreground and background.
For more information about the lighted area, see “Selecting the lighted area”
(page 604).
Notes
• If you select [Multiply] in the <Fill Blending Mode> group of the Light
Color Adjust menu (see page 617), the light effect is not applied to the
background, even if you select BKGD or Both.
• If the setting of [Brilliancy] in the <Fill Source> group of the Light Color
Adjust menu (see page 617) is 100.00, the light effect is not applied to the
background, even if you select BKGD or Both.
• When the global effect Combiner is set to Mix or Depth, the light effect is
not applied to the background, even if you select BKGD or Both.
Knob Parameter Adjustment Setting values
5 Amp Distance of light
–100.00 to +100.00
a)
To Next Page
Loading...
