Chapter 11 DME Operations
615
DME Special Effect Operations
To select Surface Flat
Press [Surface Flat], turning it on.
If you have selected anything other than Flat in the <Surface Select> group of
the Spot Lighting menu, the part corresponding only to the surface being struck
by the currently set light from the light source is shown in the same way as if
Flat had been selected.
To set the shape of the light
1
Press [Shape], turning it on.
2
Set the following parameters.
•SD format
a) For more information about the shape patterns, see “Shape Patterns” (page 875) in the
Appendix.
b) 0 is a round shape, and 100 is the shape itself. Smaller values make the pattern more
rounded.
c) –1.00 is one rotation in the counterclockwise direction. +1.00 is one rotation in the
clockwise direction.
•HD format
a) For more information about the shape patterns, see “Shape Patterns” (page 875) in the
Appendix.
b) 0 is a round shape, and 100 is the shape itself. Smaller values make the pattern more
rounded.
c) –1.00 is one rotation in the counterclockwise direction. +1.00 is one rotation in the
clockwise direction.
To rotate the shape pattern
1
Press [Shape Speed], turning it on.
Knob Parameter Adjustment Setting values
1 Shape Ptn Shape pattern
1 to 2
a)
2 Size Shape size 0.00 to 6.00
3 Deform Amount of shape deformation
0.00 to 100.00
b)
4 Soft Softness of shape pattern 0.00 to 100.00
5 Angle Angle of shape pattern rotation
–8.00 to +8.00
c)
Knob Parameter Adjustment Setting values
1 Shape Ptn Shape pattern
1 to 2
a)
2 Size Shape size 0.00 to 24.00
3 Deform Amount of shape deformation
0.00 to 100.00
b)
4 Soft Softness of shape pattern 0.00 to 100.00
5 Angle Angle of shape pattern rotation
–8.00 to +8.00
c)
To Next Page
Loading...
