Chapter 11 DME Operations
616
DME Special Effect Operations
The display on knob 5 that was visible when [Shape] was selected changes.
2
Set the following parameter.
a) –100.00 is four rotations per second in the counterclockwise direction, and +100.00 is four
rotations per second in the clockwise direction. 0.00 stops the rotation.
To change the light to a ring shape
Notes
If you select Parallel or Whole (see page 612) in the <Spot Mode> group and
shaping is disabled, the Ring parameter cannot be set.
1
Press [Ring], turning it on.
2
Set the following parameter.
•SD format
a) –1.00 is one rotation in the counterclockwise direction and +1.00 is one rotation in the
clockwise direction.
Notes
There is no Radius setting when Line is selected in the <Spot Mode>
group.
•HD format
a) –1.00 is one rotation in the counterclockwise direction and +1.00 is one rotation in the
clockwise direction.
Knob Parameter Adjustment Setting values
5 Speed Rotation direction and speed
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Offset Offset from center position (radius) –6.00 to +6.00
2 Radius Radius of ring 0.00 to 6.00
3 Angle Rotation angle of ring
–8.00 to +8.00
a)
Knob Parameter Adjustment Setting values
1 Offset Offset from center position (radius) –24.00 to +24.00
2 Radius Radius of ring 0.00 to 6.00
3 Angle Rotation angle of ring
–8.00 to +8.00
a)
To Next Page
Loading...
