Chapter 13 Keyframe Effects
707
Specifying the Region and Edit Points
Setting the Edit Points
Keyframe control block
To set the edit points, use any of the following operations in the keyframe
control block.
• To move the edit point to the keyframe immediately after the current time
(the position at which the effect is currently stopped), press the [NEXT KF]
button.
• To move the edit point to the keyframe immediately before the current time,
press the [PREV KF] button.
• To move the edit point to a keyframe specified by number, press the [GO TO
KF/TC] button turning its LED on, then enter the keyframe number with the
numeric keypad in the numeric keypad control block, and press the [ENTER]
button to confirm.
• To move the edit point to a specified timecode, holding the [SHIFT] button,
press the [GO TO KF/TC] button turning its LED on, then enter the timecode
value with the numeric keypad in the numeric keypad control block and press
the [ENTER] button to confirm.
EDIT ENBL button
CONST DUR button
Edit point specification buttons
Editing buttons
SHIFT button
To Next Page
Loading...
