Chapter 15 Utility/Shotbox
775
Shotbox Register Creation
Shotbox register name: This shows the shotbox register name.
2
If necessary, switch the region display by pressing one of the following
buttons in the status area.
M/E, P/P: Shows the allocations for M/E-1 (“M/E1”) and P/P (“P/P”).
User: Shows the allocations for User1 (“USR1”) to User8 (“USR8”).
DME: Shows the allocations for DME ch1 (“DME1”) to ch8 (“DME8”).
DEV1-8: Shows the allocations for Device1 (“DEV1”) to Device8
(“DEV8”).
DEV9-12: Shows the allocations for Device9 (“DEV9”) to Device12
(“DEV12”).
Misc: Shows the allocations for P-Bus (“PBUS”), GPI (“GPI”), Router
(“RTR”), and Macro (“MCRO”).
3
Using any of the following methods, select the register you want to create
(or edit).
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
4
Press [Edit].
The Edit menu appears, and it is now possible to make the settings for the
specified register.
You can also use knob 1 to select the register in this menu.
In the status area, the shotbox register status for each region appears.
5
Using any of the following methods, select the desired region. You may
select more than one region.
• Press directly on the region display in the status area, turning it to reverse
video.
• Press [ALL] to select all regions.
• To select all switcher-related regions (M/E, P/P, User), press
[SWR ALL].
• To cancel a selection, press once more to return to the normal display.
6
In the <Assign> group, select the snapshot or effect to be allocated to the
region.
Snapshot: Allocate a snapshot register.
Effect: Allocate a keyframe effect.
Knob Parameter Adjustment Setting values
1 Shotbox Reg Shotbox register number 1 to 99
To Next Page
Loading...
