Chapter 15 Utility/Shotbox
776
Shotbox Register Creation
• If the selected register is locked, a confirmation message appears asking
whether or not to cancel the operation. Press [OK] to return to the
previous menu display without carrying out the registration.
• If the operation is carried out, the region selected in step 5 is registered
on the master timeline, and the parameters are now valid.
7
Depending on the selection in step 6, set the parameters as follows.
• When a snapshot is selected
• When an effect is selected
a) For the DME region, you can also set register numbers 101 to 199, 201 to 299, and 301 to
399.
For P-Bus and Device1 to Device12, you can also set register numbers 1 to 250.
8
To run the allocated effect as soon as it is recalled, press [Auto Run],
turning it on.
9
Repeat steps 5 to 8 as required.
10
In the <Store> group, press [Store] to save the setting.
To return to the state before saving the setting
In the <Store> group, press [Undo].
To execute the settings to check them
Press [Recall] to execute the shotbox.
Knob Parameter Adjustment Setting values
3 Snapshot Snapshot register number 1 to 99
Knob Parameter Adjustment Setting values
3 Effect Keyframe effect number
1 to 99
a)
To Next Page
Loading...
