Chapter 15 Utility/Shotbox
778
Shotbox Execution
• The [RCALL] button lights amber.
• The display shows the last recalled register number.
2
With the numeric keypad buttons, enter the desired register number.
• The display now shows the entered register number.
• If the specified register is empty, an “E” automatically appears after the
register number.
3
Press the [ENTER] button.
• This runs the specified shotbox register.
• The number of the recalled register appears in the display.
• The region selection buttons corresponding to the regions for which the
effect is set light.
• If auto run is set for the specified shotbox register, on recall the effect is
immediately executed.
• If you recall an empty register, then shotbox execution has no effect.
When auto run is not set for the recalled register
Simply recalling the register does not run the effect. To do this, in the
keyframe control block, press the [RUN] button.
To Next Page
Loading...
