Chapter 16 Macros
817
Macro Attachment Assigning
While the [POST MCRO] button is held down:
• Buttons set in post macro mode: flash amber
• Buttons set in macro only mode: flash green
Setting a macro attachment to a fader lever
You can set a macro attachment to any particular position of a fader lever in the
transition control block.
Notes
• In macro only mode it is not possible to set a macro attachment.
• It is not possible to set a macro attachment to a fader lever in the downstream
key control block.
1
Recall the macro register that you want to assign to the fader lever. (1 to
250)
For details of recall see page 792.
2
Move the fader lever to the position where you want to set the macro
attachment.
3
Hold down the [PRE MCRO] or [POST MCRO] button
1)
assigned to a
utility/shotbox control block or user preference button, and press the
[LIMIT SET] or [PRIOR SET] button in the control block containing the
fader lever operated in step 2.
1) Only when setting a macro attachment to the start point or end point of fader lever
operation, use [PRE MCRO] and [POST MCRO] in distinction, as follows.
To set the operation start point (0%): hold down [PRE MCRO] for the operation.
To set the operation end point (100%): hold down [POST MCRO] for the operation.
This assigns the register recalled in step 1 to the fader lever position
selected in step 2.
To check a macro attachment setting
Hold down the [PRE MCRO] or [POST MCRO] button assigned to a utility/
shotbox control block or user preference button. While it is held down, the
fader lever position where the macro attachment is set appears in the following
places.
• Transition indicator in the transition execution section: The indicator
lights at the position where the macro attachment is set.
• Transition rate indication in the transition execution section: This shows
the fader lever position where the macro attachment is set, as a percentage
value. (Fader lever start position as 0%, end position 100%)
To Next Page
Loading...
