Sony MVS-8000X SystemMVS-7000X System - Page 158

USO RESTRITO
158
Resizer
Knob
Parameter
Adjustment
Setting values
1
H
Horizontal gain
adjustment
0.00 to 100.00
2
V
Vertical gain
adjustment
0.00 to 100.00
3
All
Both horizontal
and vertical
adjustment
H value is
displayed
Chapter
4
Keys
However, <Mosaic/Defocus Mode> appears in place
of <Defocus Mode>.
Notes
If defocus is enabled, and in the <Mosaic/Defocus Mode>
group you select Video/Key, then the crop and mask are
disabled.
Applying a mosaic
1 In the M/E-1 >Key1 >Processed Key/Resizer
>Enhanced Effect menu, press [Mosaic], turning it on.
2 Set the parameters.
This operation is the same as the DME mosaic setting.
For more details, see “Mosaic Settings” (page 307).
3 In the < Mosaic/Defocus Mode > group, select the
signal to which to apply the mosaic effect.
Video/Key: Video signal and key signal
Video: Video signal only
Notes
If mosaic is enabled, and in the <Mosaic/Defocus
Mode> group you select Video/Key, then the crop and
mask are disabled.
To make the mosaic like a relief pattern
1 With [Mosaic] on, press [Relief], turning it on.
2 In addition to the mosaic parameters, set the following
parameters.
Knob
Parameter
Adjustment
Setting values
3
Gain
Relief depth of
mosaic cells
0.00 to 100.00
4
Angle
Light source
direction
–8.00 to +8.00
Defocusing
1 In the M/E-1 >Key1 >Processed Key/Resizer
>Enhanced Effect menu, press [Defocus], turning it
on.
2 Set the parameters.
This operation is the same as the defocusing setting
when using the DME with the DME dedicated
interface (see page 303).
Applying a mask to mosaic or defocus
1 In the M/E-1 >Key1 >Processed Key/Resizer
>Enhanced Effect menu, press [Dual Rszr Effect],
turning it on.
2 Press [Mask], turning it on.
This enables the mask function.
To make the mask settings, continue with steps 3 and
following.
3 Press [Mask Menu].
The Mask menu appears.
4 In the <Mask Source> group, select either of [Box]
and [Circle].
Box: Use a box pattern as the mask signal.
Circle: Use a circle pattern as the mask signal.
5 Set the parameters.
The valid ranges of the parameter values depend on the
combination of signal format (SD/HD) and aspect
ratio (4:3/16:9) selected in the system, as follows.
The parameters are the same as for drop shadow.
For more details, see “Applying a drop shadow”
(page 157), except that knobs 3 and 5 are as follows.
Knob
Parameter
Adjustment
Setting values
3
Size
Size
0.00 to 100.00
5
Aspect
Aspect ratio
–100.00 to
+100.00
The rotation and inversion operations are the same as
for a DME mask setting.
For more details, see “Mask Settings” (page 310).
Notes
• When a mask effect is applied to a border, the
boundary becomes discontinuous, giving an
unnatural effect. Avoid applying a mask to a border.
• If mosaic or defocus is enabled, and in the <Mosaic/
Defocus Mode> group you select Video/Key, then
the mask is disabled.