Sony MVS-8000X SystemMVS-7000X System - Page 167

USO RESTRITO
Basic Procedure for Wipe Settings 167
Chapter
5
Wipes
• Modulation
• Spring
• Spiral
The following sections show examples of modifying the
main pattern.
Specifying the wipe direction (Direction)
You can specify the direction of the wipe: the regular
direction is referred to as “normal,” and the other direction
as “reverse.” You can also select alternating directions
each time the transition is completed (normal/reverse
mode).
The parameter Split No specifies the number of splits.
The parameter Spacing specifies the spacing between
adjacent patterns.
1 In the M/E-1 >Wipe menu, select HF4 ‘Edge/
Direction.’
The Edge/Direction menu appears.
2 Press [Split], turning it on.
3 Set the following parameters.
Knob
Parameter
Adjustment
Setting values
1
Split No
Number of splits
1 to 4 (integer)
2
Spacing
Spacing
between
adjacent
patterns
0.00 to 100.00
Normal
Reverse
To specify the wipe direction in a menu
1 In the M/E-1 >Wipe menu, select HF4 ‘Edge/
Direction.’
The Edge/Direction menu appears.
2 In the <Direction> group, specify the wipe direction.
Normal: regular direction
Normal/Reverse: alternate between regular and
reverse for each transition
Reverse: reverse direction to normal
To specify the wipe direction with a button in the
transition control block
In the transition control block of each of the M/E-1 to M/
E-3 and PGM/PST banks, press the following direction
selection buttons.
NORM: Normal
NORM/REV: Normal/reverse
REV: Reverse
Splitting the wipe pattern (Split)
This splits the pattern, making the parts of the wipe move
in opposite directions.
Modifying the wipe pattern edge (Edge)
You can apply a border to the pattern, soften the edges, or soften the applied border.
Border
Soft
Soft border
Border: You can adjust the border width.
Soft: You can adjust the edge softness.
Soft border: You can adjust the border width, and the
softness of the inner and outer edges of the border.
When a border or soft border is selected, the signal filling
the border is called edge fill. For the edge fill, you can use
a matte generated by the dedicated color matte generator,
or the signal selected on the utility 2 bus. A matte can
include color 1 and color 2, and a combination of the two
colors (a “color mix”).
1 In the M/E-1 >Wipe menu, select HF4 ‘Edge/
Direction.’
The Edge/Direction menu appears.
Split Off Split On
2 In the <Edge> group, select the edge type.