Sony MVS-8000X SystemMVS-7000X System - Page 169

USO RESTRITO
Basic Procedure for Wipe Settings 169
Knob
Parameter
Adjustment
Setting values
1
H Multi
Number of
repetitions of
pattern
horizontally
1 to 63
2
V Multi
Number of
repetitions of
pattern
vertically
1 to 63
3
Invert Type
Replication
layout
1 to 4
a)
Knob
Parameter
Adjustment
Setting values
1
Aspect
Aspect ratio
–100.00 to
+100.00
a)
Knob
Parameter
Adjustment
Setting values
1
Angle
Angle of pattern
rotation
–100.00 to
+100.00
a)
Knob
Parameter
Adjustment
Setting values
1
Speed
Rotation rate of
pattern
–100.00 to
+100.00
a)
Chapter
5
Wipes
Knob
Parameter
Adjustment
Setting values
2
Soft
Edge softness
0.00 to 100.00
5 If you selected Pattern in step 4, if required, the
following modifiers can be added. After selecting a
wipe mix, skip to step 6.
When turning [Position] on and setting the pattern
position
Knob
Parameter
Adjustment
Setting values
1
Position H
Horizontal
position
–200.00 to
+200.00
a)
2
Position V
Vertical position
–200.00 to
+200.00
a)
a) See page 169.
When turning [Multi] on and using replications of
the same pattern
6 To adjust color 1, set [Color 1] on, and to adjust color
2 set [Color 2] on, then adjust the parameters.
Knob
Parameter
Adjustment
Setting values
1
Luminance
Luminance
0.00 to 100.00
2
Saturation
Saturation
0.00 to 100.00
3
Hue
Hue
359.99 to 0.00
7 To interchange color 1 and color 2, press [Color
Invert], turning it on.
Setting the wipe position (Positioner)
When you turn on this function, you can move the wipe
pattern to any position.
Positioner Off Positioner On
a) See page 171.
When turning [Aspect] on and setting the aspect
ratio of the pattern
a) See page 171.
When turning [Angle] on in the <Rotation> group
and slanting the pattern
a) See page 170.
When turning [Speed] on in the <Rotation> group
and rotating the pattern at a constant rate
a) See page 170.
• The parameter H Position controls the horizontal
position of the pattern.
A negative value moves the pattern to the left, and a
positive value moves the pattern to the right.
• The parameter V Position controls the vertical position
of the pattern.
A negative value moves the pattern down, and a positive
value moves the pattern up.
You can set the position independently for the main pattern
and sub pattern.
1 In the M/E-1 >Wipe menu, select HF5 ‘Main Modify.’
The Main Modify menu appears.
2 In the <Position> group, press [Position], turning it on,
and set the pattern position.
Knob
Parameter
Adjustment
Setting values
1
Position H
Horizontal
position
–200.00 to
+200.00
2
Position V
Vertical position
–200.00 to
+200.00
To return the pattern position to the center of the
screen
In the <Position> group, press [Center].
To move the pattern from its current position to
the center through the course of a transition
In the <Position> group, press [Auto Center], turning it on.