For details of assigning to region selection buttons, see
Chapter 19 “Control Panel Setup (Panel)” (Volume 2).
In the Frame Memory menu, effect creation follows the
image file names. Of the eight characters in the file names,
if files have the same characters except for the last three
characters they are treated as an image file group, and the
effect is created with the last three (numeric) characters in
sequence.
Notes
When creating the effect in pair mode (see page 203), the
files used must be main files and sub files with the same
last three (numeric) characters in the file name.
To recall a continuous sequence of still images, create an
effect in the user region with the still image files as a
keyframe, and run the created effect.
Notes
With the 720P format or 1080P format, you can
continuously recall images using the frame memory in
units of two frames only.
Creating an effect with still image files as a
keyframe
1
In the Frame Memory menu, select VF1 ‘Still’ and
HF5 ‘Create Key Frame.’
The Create Key Frame menu appears.
•
A thumbnail appears for each group of files having
the same characters, except for the last three
characters, in the file name.
•
When [Pair] is on, only pair files (each pair
comprising a main file and a sub file) appear.
•
When [Pair] is off, both single files and pair files all
appear.
2
In the frame memory selection area, select the frame
memory to be assigned (see page 207).
3
Select the desired folder in the folder selection area.
By pressing [More] to switch the display, you can
select from a maximum of 12 folders.
Thumbnails of the files within the selected folder
appear.
4
Turn the knob to select the register number in the user
region.
Notes
To search for an empty register in the user region, use
the numeric keypad control block or the Multifunction
Flexi Pad control block.
For details, see step 3 of “Recalling a Register” in
Chapter 13 (Volume 2).
5
Use the arrow keys or turn the knobs to scroll the
thumbnail display of the files.
Thumbnail
display
scrolling
6
Select the thumbnail of the files to be used for the
keyframe.
7
If necessary, turn the knob to check the animation
effect in the thumbnail display.
00:00:00 to
maximum value
8
Using the region selection buttons in the numeric
keypad control block or the Multifunction Flexi Pad
control block, select one of the regions (User1 to
User8) to which the frame memory output signals have
been assigned.
9
Carry out either of the following.
•
To clear the effect register selected in step 4, and
create a new effect: press [Create Key Frame].
•
To add to the end of the effect register selected in
step 4, press [Append Key Frame].
A confirmation message for creating the effect
appears.
If there is an inappropriate condition for creating the
effect, an error message appears.
For details of error messages, see “Error Messages”
in the Appendix (Volume 2).
10
Press [OK].
This creates the effect in the selected user region
register.
To Next Page
Loading...
