Chapter
10
Special
Functions
Notes
•
When using the DME through SDI interface with [Auto
Crop] being off, side flags are not added to the new
image during DME wipe.
DME wipe from a 4:3 image to another 4:3
image (when side flags are on for both
images)
Wipe action using squeeze (No. 1031)
• For signals with the following DME wipe pattern
selected on the DME external video bus (gray part
shown in the pattern illustration), side flags are not
applied when auto side flags are set to Off.
-
Two-channel page turn
-
Two-channel page roll
-
Two-channel frame in-out
-
Two-channel brick
-
Three-channel brick
The following illustration shows the action in a DME
wipe.
DME wipe from a 4:3 image to a 16:9 image
Wipe action using slide (No. 1001)
16:9 image
Side flag areas
a)
Side flag areas
Auto crop off
4:3 image
(Side flags on)
Side flag areas
Side flag areas
Auto crop on
Side flag area
4:3 image
(Side flags on)
Auto crop off Auto crop on
a) When using the DME through SDI interface, side flags are not added
during a DME wipe.
Side flag areas
4:3 image
(Side flags on)
To Next Page
Loading...
