Sony MVS-8000X SystemMVS-7000X System - Page 330

USO RESTRITO
330
Applying Special Effects (Lighting and Recursive Effects)
Knob
Parameter
Adjustment
Setting values
1
Luminance
Luminance
0.00 to 100.00
2
Saturation
Saturation
0.00 to 100.00
3
Hue
Hue
359.99 to 0.00
Knob
Parameter
Adjustment
Setting values
1
X
X-value of
bar center
point
–8.00 to +8.00
a)
b)
–32.00 to +32.00
c)
4
Width
Width of bar
0.00 to 100.00
5
Soft
Softness of
edges
0.00 to 100.00
Knob
Parameter
Adjustment
Setting values
1
X
X-value of
bar center
point
–8.00 to +8.00
a) b)
–24.00 to +24.00
c)
–32.00 to +32.00
d)
2
Y
Y-value of
bar center
point
–6.00 to +6.00
a)
–4.50 to +4.50
b)
–18.00 to
+18.00
c) d)
3
Angle
e)
Angle of bar
–8.00 to +8.00
4
Width
Width of bar
0.00 to 100.00
5
Soft
Softness of
edges
0.00 to 100.00
Knob
Parameter
Adjustment
Setting values
1
Luminance
Luminance
0.00 to 100.00
2
Saturation
Saturation
0.00 to 100.00
3
Hue
Hue
359.99 to 0.00
Chapter
11
DME
Operations
Shade
area
Highlight
area
Ambient
area
Setting the bar shape of the shade area
You select [Preset] in step 3 of “Applying the Lighting
effect” (page 329), and then use the following procedure to
The three regions for which the light intensity can be set
Setting the bar shape of the highlight area
When you select [Bar] or [Preset] in step 3 of “Applying
the Lighting effect” (page 329), use the following
procedure to set the shape of the bar.
1 Turn [Light Modify] on.
2 Adjust the following parameters.
set the bar shape of the shade area.
1 Turn [Shade Modify] on.
2 Adjust the following parameters.
–24.00 to +24.00
a) For SD 4:3
b) For SD 16:9
c) For HD 4:3
d) For HD 16:9
e) There are some nonlinear effects for which Angle cannot be used.
a) For SD 4:3 and SD 16:9
b) For HD 4:3
c) For HD 16:9
Setting the color of the shade in the shade
area
1 Turn [Shade Color] on.
2 Adjust the following parameters.
Center point
of bar
Bar width
Bar angle
Setting the bar mode of the highlight area
You select [Bar] in step 3 of “Applying the Lighting
effect” (page 329), and then use the following procedure to
set the bar mode of the highlight area.
Bar shape parameters
Setting the color of the light in the
highlight area
1 Turn [Light Color] on.
2 Adjust the following parameters.
Notes
The bar mode of the highlight area is not supported on the
MVE-8000A.
1 Select the mode in the <Bar Light Mode> group.
Normal: Emphasizes the bar highlight area.
Specular: An effect like light striking a surface with
metallic reflections.