Sony MVS-8000X SystemMVS-7000X System - Using the M;E-4 or M;E-5 Bank; Assigning a Button for M;E-4 or M;E-5 Selection in the Setup Menu

USO RESTRITO
396
Using the M/E-4 or M/E-5 Bank
Control block
Button
Menu number
Reference in User Guide
“Control Panel Setup (Panel)” and “Cross-Point Settings (Xpt
Assign Menu)” in Chapter 19 (Volume 2)
Cross-point control
Reentry buttons
7322.1
“Creating Cross-Point Assign Tables”
block
7322.5
Engineering Setup >Panel >Xpt Assign >Table Button Assign
menu
Engineering Setup >Panel >Xpt Assign >Main, V/K Pair Assign
menu
Entire switcher bank
-
7321
“Interchanging the Bank Order or Disabling Operation”
Engineering Setup >Panel >Config menu
Key control block
Delegation buttons
7321.29
“Assigning Functions to Key Control Block Buttons”
Engineering Setup >Panel >Config >Link/Program Button >Key
Control Module >Button Assign menu
Device control block
Region selection
buttons
7321.17
“Assigning Functions to the Device Control Block”
Engineering Setup >Panel >Config >Link/Program Button
>Joystick/Trackball Module menu
Numeric keypad
control block
Region selection
buttons
7321.7
“Assigning a Region to the Region Selection Buttons in the
Numeric Keypad Control Block or Multifunction Flexi Pad
Control Block”
Engineering Setup >Panel >Config >10 Key Region Assign
menu
Fade to black
control block
Preview selection
buttons
7321.13
“Assigning Preview Output to Preview Selection Buttons”
Engineering Setup >Panel >Config >Link/Program Button
>Fade To Black Module menu
Menu control block
Top menu selection
buttons
7321.19
“Assigning Functions to the Menu Control Block Top Menu and
User Preference Buttons”
Engineering Setup >Panel >Config >Link/Program Button
>Menu Panel menu
Multifunction Flexi
Pad control block
Region selection
buttons
7321.7
“Assigning a Region to the Region Selection Buttons in the
Numeric Keypad Control Block or Multifunction Flexi Pad
Control Block”
Engineering Setup >Panel >Config >10 Key Region Assign
menu
Appendix
(Volume
1)
Using the M/E-4 or M/E-5 Bank
Assigning a Button for M/E-4 or M/E-5 Selection in the Setup Menu
• In the factory defaults for this system, M/E-4 and M/E-5
are not assigned to buttons on the control panel.
• To select M/E-4 or M/E-5, assign buttons in the Setup
menu according to the following table.
Notes
On the MVS-8000X, M/E-5 cannot be used. M/E-5
operation and settings are disabled, even if they appear in
the menu.