Overall Control Panel Settings (Config Menu)
Chapter
19
Control
Panel
Setup
(Panel)
3
In the button indications on the left, press the button
for the assignment.
4
Using any of the following methods, select the signal
to be assigned.
•
Press directly on the list on the right.
•
In the list on the right, press the arrow keys to scroll
the reverse video cursor.
•
Turn the knob.
5
Press [Set].
This assigns the signal selected in the list to the button.
To cancel an assignment
Select the button, then press [Clear].
This leaves nothing assigned.
To return all preview selection button
assignments to the factory default state
In the Fade To Black Module menu, press [Default].
Assigning Functions to the Device
Control Block
Assigning devices or functions to the
device selection buttons and other buttons
of the device control block (search dial)
You can assign devices and functions to the device
selection buttons, SBOX buttons and [DELAY] button of
the device control block (search dial).
1
In the Panel >Config menu, press [Link/Program
Button].
The Link/Program Button menu appears.
2
Press [Device Control Module].
The Device Control Module menu appears.
The left of the status area shows the device selection
buttons, SBOX buttons and [DELAY] button of the
device control block (search dial). The list on the right
shows the devices and functions that can be assigned.
3
In the button displays on the left, press the button for
the assignment.
4
Using any of the following methods, select the device
or function to be assigned.
•
Press directly on the list on the right.
•
In the list on the right, press the arrow keys to scroll
the reverse video cursor.
•
Turn the knob.
Selection of
device or function
to be assigned
5
Press [Set].
To cancel an assignment
Select the button, then press [Clear].
This removes the assignment to that button.
To return all device selection button assignments
to the factory default state
In the Device Control Module menu, press [Default].
Assigning devices and functions to the
region selection buttons of the device
control block (trackball)/device control
block (joystick)
You can assign devices and functions to the region
selection buttons of the device control block (trackball)/
device control block (joystick).
1
In the Panel >Config menu, press [Link/Program
Button].
The Link/Program Button menu appears.
2
Press [Joystick/Trackball Module].
The Joystick/Trackball Module menu appears.
3
In the lower right <Mode Select> group, select
[Device/Clip] or [Wipe/RSZR].
Device/Clip: Assignment while the device control
block [DEV] button is lit
Wipe/RSZR: Assignment while no button is lit on the
device control block or the [RSZR] button is lit
According to the selection, the left of the status area
shows the region selection buttons of the device
control block. The list on the right shows the devices
and functions that can be assigned.
4
In the button displays on the left, press the button for
the assignment.
5
Using any of the following methods, select the device
or function to be assigned.
•
Press directly on the list on the right.
•
In the list on the right, press the arrow keys to scroll
the reverse video cursor.
•
Turn the knob.
To Next Page
Loading...
