Overall Control Panel Settings (Config Menu)
Chapter
19
Control
Panel
Setup
(Panel)
3
Using any of the following methods, scroll the display.
•
Press the arrow keys.
•
Turn the knob.
4
In the button indications on the left, press the button
for the assignment.
5
Using any of the following methods, select the menu
or action to be assigned.
•
Press directly on the right list.
•
Press the arrow keys on the right list to scroll the
reverse video cursor.
•
Turn the knob.
Select the menu
or action
6
Press [Set] you confirm the setting.
This assigns the menu or action selected in the list to
the button.
To cancel an assignment, select the button, then press
[Clear].
To return all button assignments to the factory default
state, in the Menu Panel menu, press [Default].
Assigning Functions to the Buttons
in the Multifunction Flexi Pad
Control Block
You can assign functions to the buttons in the various parts
of the Multifunction Flexi Pad control block in the
following menus.
Mode selection buttons: Multi Function Module menu
Region selection buttons: 10 Key Region Assign menu
Memory recall buttons: Multi Function Module menu
For details of assignment of regions to the region selection
buttons, see “Assigning a Region to the Region Selection
Buttons in the Numeric Keypad Control Block or
Multifunction Flexi Pad Control Block” (page 570).
1
In the Panel >Config menu, press [Link/Program
Button].
The Link/Program Button menu appears.
2
Press [Multi Function Module].
The Multi Function Module menu appears.
3
Press one of the following three buttons displayed in
the button area.
Mode Sel Assign: To assign a function to the mode
selection buttons
Eff Edit Assign: To assign a function to a button in the
memory recall section for effect editing (when the
[EFF] and [EDIT ENBL] buttons are pressed)
Macro Edit Assign: To assign a function to a button
in the memory recall section for macro editing
(when the [MCRO] and [EDIT ENBL] buttons are
pressed)
The left side of the status area shows an image of each
button, and the right side shows a list of modes and
functions to be assigned.
4
In the button indications on the left, press the button
for the assignment.
5
Using any of the following methods, select the mode
or function to be assigned.
•
Press directly on the right list.
•
Press the arrow keys on the right list to scroll the
reverse video cursor.
•
Turn the knob.
When Mode Sel Assign is selected
When Eff Edit Assign or Macro Edit Assign is
selected
The following modes and functions can be selected.
Mode selection buttons
To Next Page
Loading...
