Auxiliary Bus Control Block Settings (Aux Assign Menu)
Chapter
19
Control
Panel
Setup
(Panel)
Lock: Acts as a shift button, and pressing the button
toggles between the shifted and unshifted states of the
source selection buttons.
Off: Acts as a cross-point button, that is, button number 16
on a 16-button system, button number 24 on a 24-
button system, and button number 32 on a 32-button
system.
To expand the shift function
To set the [KEY] button as a shift operation expansion
button, in the Source Table Assign menu select the source
table, then in the <Expand Xpt Shift Assign> group, press
[Key Button].
In order not to expand the shift operation, press [No
Assign] in the <Expand Xpt Shift Assign> group.
Assigning levels to a level selection button
To assign levels to the [LEVEL1] to [LEVEL4] buttons in
the auxiliary bus control block, use the following
procedure.
1
In the Panel >Aux Assign >RTR Mode Setting menu,
press [Level Button Assign].
The Level Button Assign menu appears. The status
area shows a list of the assignment status of levels to
each button.
2
In the <Level Button Select> group, select the button
you want to set.
3
In the <Level Assign> group, press the levels you want
to assign to the button, turning them on.
You can select plural of levels. You can also make a
selection that overlaps that of another button.
Selecting a destination selection button for
a snapshot
To set whether snapshots are recalled for each destination
selection button individually, use the Panel >Aux Assign
>RTR Mode Setting menu as follows.
1 Use any of the following methods to select the
destination selection button to which the setting
applies.
•
Press directly on the list on the left of the status area.
•
Press the arrow keys to scroll the reverse video
cursor.
•
Turn the knob.
2 Press [SS Enable], turning it on or off.
On: When a snapshot applying to the router is
recalled, the recall also applies to the selected
destination selection button.
Off: When a snapshot applying to the router is
recalled, the recall does not apply to the selected
destination selection button.
Notes
When a destination selection button is set to Inhibit,
then even if SS Enable is on, the snapshot for that
destination is not recalled.
Selection of
destination
selection button
To Next Page
Loading...
