pg. 54
Outputs
The next setup item we need to configure are the OUTPUTS. Why outputs before inputs? Well, we
need to see a working output on a monitor to see if we have working inputs.
Please go to menu page 7333 (ENG SETUP->SWITCHER->OUTPUT. In the table, you can see what has, by
default, been assigned to each output connector on the back of the switcher. If you have already
hooked up a monitor to an output and that output has been assigned as “P/P OUT1” (by default it’s
Output 7) then you’re set.
If your physical connection does not match up, let’s set it. Please press OUTPUT ASSIGN.
To Next Page
Loading...
