Sony MVS -8000X - Table Copy

pg. 62
Let’s set the whole switcher to use TABLE1.
Please press the small “ALL” Button right below the left table. The entire table will now be highlighted.
Next, on the right table, please select Table1. Finally press the purple “TABLE ASSIGN SET” button.
Now, the entire switcher is using Table1 for mapping.
Table Copy
Just to make sure we are using the defaults and we are working with a clean slate let’s initialize Table1
so it matches the main table. Please press the TABLE COPY button. On the left side, please select the
bottom entry, MAIN. On the right side, please select Table1 then press the purple COPY button.