pg. 68
Using the internal Format Converters
If you have purchased the internal format converters for your switcher and would like to set them up,
please follow this section; otherwise please skip down to “Saving Our Work”. We have already set the
type of input(s) the FCs will be expecting earlier in this document. The input methods for MVS-7000X
and 8000X are a little different, so please refer to the correct section, below.
Format Converters for MVS-8000X
The MVS-8000X has dedicated BNC inputs for its format converters. As mentioned earlier in this
document, those inputs can be found on Slot #12. Mapping a format converter’s input to a V/K pair and
a crosspoint button are exactly the same procedures as we covered earlier. The only difference is the
source number. On the 8000X, the format converter inputs are found on source # 165-180. So, using
the same mapping procedures, make a Main V/K pair, except this time use a FC input.
Format Converters for MVS-7000X
The MVS-7000X has assignable FC mapping, rather than dedicated inputs. Please jump to menu page
7332 and select “FC Input Select”.
To Next Page
Loading...
