Sony MVS -8000X - Setting the Side Flag Video Material and Operation

Chapter 20 Switcher Setup (Switcher)
1172
Settings for Switcher Configuration (Config Menu)
Setting the Side Flag Video Material and Operation
Make settings relating to the video material (4:3 aspect ratio) for applying side
flags.
For details of side flag operations, see “Side Flag Settings” in Chapter 10
(Volume 1).
Setting the aspect ratio (4:3/16:9)
1 In the Switcher >Config menu, press [Side Flags].
The Side Flags menu appears.
The status area lists the video/key pair numbers, video signal source
names, and aspect ratio settings (16:9/4:3).
2 Using any of the following methods, select the pair number for which you
want to make the setting.
• Press directly on the list in the status area.
• Use the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
• To select all of the pair numbers, press [ALL].
3 In the <Aspect> group, press [4:3].
If you select [16:9], no side flags are applied.
To set 4:3 video material to have side flags applied automatically
You can make a setting so that when a signal with aspect ratio set to 4:3 is
selected in the cross-point control block, side flags are automatically applied.
To do so, in the Switcher >Config >Side Flags menu press [Auto Side Flags].
Pressing this button toggles the setting on and off.
This setting applies to all of the M/E and PGM/PST banks.
To set to crop to 4:3 when a DME wipe is executed
When side flags are enabled, you can automatically crop an image as set to be
a 4:3 image when executing a DME wipe.
Knob Parameter Adjustment Setting values
1 V/K Pair No Selection of a V/K pair by its
number in the list
1 to 300
2 Num Selection of number of V/K pairs
in the list
1 to 300