Chapter 14 Snapshots
870
Snapshot Operations in the Menus
The selected region name appears in the upper part of the list.
4
Using any of the following methods, select the register.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
• To select all registers, press [ALL].
5
In the <Attribute> group, press the buttons for the attributes you want to
apply, turning them on.
Carry out the following procedures for each of the attributes.
To apply the cross-point hold attributes
Notes
Applying the key disable attribute (so the key state is not reflected) to cross-
point hold requires a setting in setup. For details, see “Selecting the Bank to
Make the Settings” in Chapter 20 (Volume 3).
1
Press [XPT Hold].
The Snapshot >Attribute>Xpt Hold menu appears. The status area shows
a list of the currently selected regions and bus names.
2
Using any of the following methods, select the register.
• Press directly on the list in the status area. To select one or more buses,
press [Plural] and then select buses.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
a) Appears when the region is RTR.
b) Appears when the region is other than RTR.
• To select all registers, press [ALL].
3
When the region is set to RTR (Router) only, press [RTR Level].
Knob Parameter Adjustment Setting values
1 Register Register number 1 to 99
2 Num Select number of registers 1 to 99
Knob Parameter Adjustment Setting values
2
Destination
a)
Destination selection 1 to 128
3
Bus
b)
Bus name selection 1 and upwards
To Next Page
Loading...
