Sony MVS -8000X - Page 914

Chapter 16 Macros
914
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
2 In the numeric keypad control block, hold down the [MCRO] button, and
press the [STORE] button.
This assigns the numeric keypad control block and keyframe control block
to macro editing, and the [MCRO] button in the numeric keypad control
block and the [EDIT ENBL] button in the keyframe control block light red.
The [STORE] button in the numeric keypad control block flashes red.
3 Using any of the following methods, specify the edit point.
• To move the edit point to the event immediately following the current
macro event, press the [NEXT KF] button in the keyframe control block.
• To move the edit point to the event immediately preceding the current
macro event, press the [PREV KF] button in the keyframe control block.
• To move to an edit point by specifying an event number (the number
showing the position of the event in the macro execution sequence),
press the [GO TO KF] button in the keyframe control block, then in the
numeric keypad control block, enter the target number and confirm with
the [ENTER] button.
Inserting an event
1 Specify the edit point. (See page 913.)
2 If required, press the [AUTO INS] button in the keyframe control block to
toggle the auto insert mode on or off.
3 Create the event.
• When auto insert mode (see page 912) is on, the event is automatically
added to the macro.
• When auto insert mode is off, proceed to step 4.
4 When auto insert mode is off, press the [INS] button in the keyframe
control block.
5 Repeat steps 2 and 3 to insert the required events in the macro.
Modifying a single event
1 Specify the edit point. (See page 913.)
2 If the [AUTO INS] button is lit, press it to turn off the insert mode.
3 Create the event.