Sony MZ-NH700 - Messages

76
Messages
If the following messages flash in the display window, check the chart below.
Message Meaning/Remedy
AVLS NO
VOLUME
OPERATION
• AVLS is set to “AVLS On” and so the volume cannot rise higher.
, Set AVLS to “AVLS Off” (page 56).
BLANKDISC • A disc with no recording on it is inserted.
BUSY WAIT
A MOMENT
• The recorder is accessing disc information.
• You tried to operate the recorder while it was accessing the recorded data.
, Wait until the message goes out (in rare cases, it may take a few
minutes).
CANNOT
EDIT
• You selected, “ : Set”, “ : Release”, “Move”, or “Erase” while
recording.
• You tried to erase the track mark at the beginning of the first track or group.
• You tried to erase a track mark to combine tracks the recorder cannot
combine (a track recorded in stereo and in mono, for example).
• You tried to overwrite a track marks.
• You tried to change a title that includes characters the recorder cannot edit.
, Editing titles cannot be done if the title includes characters that cannot
be input on the recorder.
CANNOT
OPERATE
• You tried to press X or T MARK during synchro-recording.
CANNOT
RECORD OR
PLAY
• There is no audio data that can be played on the recorder.
• The audio data or disc management file has been damaged.
, Erase the whole disc (page 52) or perform the Format function
(page 55).
CANNOT SET • You tried to make the Time Mark setting during synchro-recording.
• You selected “RECVolume” while the recorder is not in recording-pause.
, Set “RECVolume” while the recorder is in recording-pause.
• You tried to make the following settings while recording.
— Disc Memory
— Play mode
— Recording mode
— Recording level
— Selection of “ :REC” in menu
CHARGE
5° C–35°C
41F–95F
• You tried to charge the rechargeable battery at a place with a temperature
outside the specified range for the recorder.
, Charge the battery at a temperature of +5°C (+41°F) to +35° C
(+95° F).
Charging • The rechargeable battery is being charged.
DATA SAVE • The recorder is writing information to the system file, such as the recorded
data or editing information.
, Wait until the message disappears from the display.