Sony MZ-R55 - On the Remote Control

25-GB
On the remote control
Labeling a disc during stop
1 Insert a disc.
To label a disc that is already in the
recorder, press p to stop.
2 Press DISPLAY for 2 seconds or
more.
” : Name” flashes in the display.
3 Press p.
The disc is ready to be labeled.
4 Turn the control to select a letter and
press p to enter.
The selected letter stops flashing and
the cursor moves to the next input
position.
DISPLAY
2 To label a track, press EDIT/ENTER
again.
To label a disc, press = or +
repeatedly until ” : Name”
flashes in the display, then press
EDIT/ENTER.
3 Follow steps 4 to 6 of ”Labeling a disc
during stop” above.
To cancel labeling, press p or T MARK.
Note
If the recording is stopped while labeling
a track or a disc, or if the next track begins
on the recording source while labeling a
track, the labeling that is input up to that
point is entered automatically.
continued
PLAY MODE
P
Control
TRACK
MARK
p
VOL +/–
Press/ Turn
P
VOL +/–
=/(•+
DISPLAY
PLAY MODE
TRACK MARK
To
Switch between capital
letters, small letters, and
marks / numbers.
Move the cursor to the
left or right.
Change the letter to the
one before / next one.
Insert a blank space to
type in a new letter.
Delete a letter and move
back all following letters
to the left.
Cancel labeling.