MZ-R55 manual Page 10 of 20
http://www.hip.atr.co.jp/~eaw/minidisc/mzr55_user_manual/manual.htm 2/9/99
1
Slide the SYNCHRO REC switch to ON.
"SYNC" lights up in the display.
2
Press and slide the REC switch to the right.
"REC" lights up in the display.
The recorder starts recording when you start playing the source player.
To stop recording, press .
Tips
-You cannot pause recording manually during synchro-recording.
-When there is no sound from the source player for more than 3 seconds during synchro-recording, the
recorder stands by for recording automatically. When the sound comes from the source player, the
recorder starts synchro-recording again. When the MD player is in recording pause for longer than 5
minutes, reocrding stops automatically.
Note
Do not switch SYNCHRO REC after step 2. Recording may not be made properly.
Recording from a microphone
Connect a microphone to the MIC (PLUG IN POWER) jack. Use a stereo microphone (ECM-717,
ECM-MS097, ECM-MS957, etc., not supplied).
1
Select the sensitivity with the MIC SENS switch.
Usually, set it to HIGH. When recording loud sounds such as a live concert, set it to LOW.
2
Insert a recordable MD.
Slide the OPEN switch to open the lid, insert a recordable MD, and close the lid.
3
Press and slide the REC switch to the right.
"REC" lights up and recording starts.
To stop recording, press
.
Recording in monaural for double the normal recording time of an MD
Before recording, make connections tot he sound source and the power source, and insert a recordable
MD.