81
GROUP FULL • You tried to create a 256th group on a disc used in Hi-MD mode or 100th
group on a disc used in MD mode.
, You can create only up to 255 groups (on a disc used in Hi-MD mode)
or 99 groups (on a disc used in MD mode) on a disc. Keep the group
number within 255 or 99.
HOLD • The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder (page 18).
IN MENU • You pressed a key on the remote control while selecting a menu on the
recorder.
LOW BATTERY • Batteries are weak.
, Charge the rechargeable battery or replace the dry battery (page 17).
MEMORY OVER • You tried to record with the recorder placed where it receives continuous
vibration.
, Put the recorder on a stable place, and start recording again.
NO
BOOKMARKED
TRACK
• You selected bookmark play without setting bookmarks.
, Set bookmarks (page 41).
NO DIGITAL
COPY
• You tried to make a copy from a disc that is protected by the Serial Copy
Management System. You cannot make copies from a digitally connected
source which was itself recorded using digital connection.
, Use analog connection instead (page 34).
NO DISC • You tried to play or record with no disc in the recorder.
, Insert a disc.
NO DISC
MEMORY
• You tried to erase a setting in the Disc Memory on a disc that contains no
settings in the Disc Memory (page 58).
NO FILE • While viewing the file list, you selected a folder that have no folders or
files
NO GROUP • You selected “Group Erase” with a disc without group setting.
, You cannot erase groups with a disc with no groups.
• You tried to release a group setting with a disc that has no groups.
, Insert a disc with group settings.
NO INPUT
SIGNAL
• The recorder could not detect digital input signals.
, Make sure that the source is connected firmly (page 21).
NON GROUPED
TRACK
• You selected “Group Move” or “Group Erase”, or you tried to label a
group while selecting a track that does not belong to a group.
, Select a track within a group you want to edit, and then do the editing
operation again.
NOT ENOUGH
POWER TO
EDIT
• You tried to edit the contents of a 1GB Hi-MD disc with insufficient
battery power for editing (page 75).
, Connect the AC power adaptor to the recorder or insert a fully charged
rechargeable battery or a new alkaline dry battery.
NOT ENOUGH
POWER TO REC
• You tried to record on a 1GB Hi-MD disc with insufficient battery power
for recording (page 72).
, Connect the AC power adaptor to the recorder or insert a fully charged
rechargeable battery or a new alkaline dry battery.
Message Meaning/Remedy
To Next Page
Loading...
Need help?
General
