Sony SVP-9020 - Page 15

Chapter 2 LHUEALIUUUIULUI
2-4(E)
Front Panel (Continued)
IND
[2]
Hi-Fi/NORM switch
This switch is used to select the audio output
signal to be output to the AUDIO MONITOR
connector on the rear panel.
Hi-Fi: When the player is playing back a signal,
MONITOR OUT switch and selector
an output audio signal, recorded in hi-fi
recording mode is output to the
HEADPHONES connector, AUDIO
MONITOR connector and TV OUT
connector.
NORM: When the player is playing back a
signal, the output audio signals, recorded in
normal recording mode are output to the
HEADPHONES connector, AUDIO
MONITOR connector and TV OUT
connectors.
CH-1/MIX/CH-2 selector
This selector is used to select the channel to be
output through the HEADPHONES connector,
AUDIO MONITOR connector, and TV OUT
connector. It can also be used to select the
channel to which the player outputs the audio
signal set with the Hi-Fi/NORM switch [|].
CH-1/MIX/CH-2 | Audio signal | Audio signal
selector output from output from
setting HEADPHONES | AUDIO
; connector MONITOR
connector and
TV OUT
connector
CH-1 channel-1 channel-1
MIX | stereo audio mixed from
signal channel-1 and
channel-2
CH-2 channel-2 channel-2
Cassette compartment
Insert an S-VHS or VHS cassette here.
Chapter 2 Location and Function of Parts and Controls
3] CTL/MENU(control signal/menu) switch
This switch selects the data to be displayed by
the time counter block [5].
CTL: reads CTL signals on the tape and
displays the tape transport time in hours,
minutes and seconds. Normally, keep the
switch set to this position.
MENU: Displays menu settings in STOP mode.
No other operations are possible in menu
mode.
'4| Indicator block
Each lamp lights in the following cases:
lamp: lights when a cassette is loaded into
the player.
AUTO OFF lamp: lights when the power is
applied but moisture has condensed inside
the player. While this indicator is lit, a
cassette can not be loaded into the player.
S-VHS lamp: lights when the player is S-VHS
playback mode.
Time counter block
This block displays the data (time or the menu
items) selected with the CTL/MENU switch (3.
[6] RESET button
Setting the CTL/MENU switch [3] to CTL
causes the tape transport time to appear on the
time counter block |5|. Pressing this button
resets the indicator to “0:00:00.”
'7| POWER switch
This switch turns on the power of the player.
The time counter block [5} will light.
'8| TIMER switch
This switch is used to enable automatic
playback with an optional timer.
OFF: no timer is used. Normally, keep the
selector set to this position.
PLAY: automatic playback with a timer.