Sony TC-WR545 - Page 16

Chapter 4 Other Operations
Use the dubbing function to copy a tape in deck A to a tape in deck B. High-speed dubbing is
convenient for dubbing entire tapes while normal-speed dubbing is handy for tape editing.
1 Insert cassettes into both tape decks.
Recorded tape Blank tape
into deck A into deck B
DIR MODE Dubbing of the
reverse side starts
==—LUtpaay independently of
= deck A.
Both sides
DIRMODE Dubbing of the
reverse side starts
= simultaneously
= => with deck A.
3 Press HIGH or NORMAL to select the
dubbing speed.
SYNCHRO DUBBING AB
~ ~~
ote NGL |
47 ys
16
4 Select the side on which to start dubbing.
To dub from the front side, press [> .
To dub from the reverse side, press <1.
5 Press Il on deck B to start dubbing.
To stop dubbing
During normal-speed dubbing, press the ll button on deck
B.
During high-speed dubbing, press the ll button on either
deck A or B.
During high-speed dubbing
Only the lf button is operative.
lf the NORM or HIGH speed indicator flashes three
times
Either one or both tabs of the cassette inserted into deck B
have been removed, making dubbing impossible for that
side. Cover the hole(s) with tape (see page 13).
Is it necessary to adjust the recording level and
select the Dolby NR system?
It is unnecessary since the tape in deck B is automatically
recorded with the same recording level and Dolby noise
reduction system as the original in deck A.
The Dolby system must, however, be set to match the tape in
deck A when the sound is monitored during normal-speed
dubbing.
Note on tape dubbing
If the sound is affected by the proximity of a television set
during high-speed dubbing, turn the television set off or
move it away from the deck.