Sony TC-WR545 - Exploded Views; Chassis Section; Front Panel Section

Dubbing Selections in a Specified Order
— RMS Dubbing (TC-WR545 only) —
Follow this procedure to dub selections being played back from an RMS program. Noie that
RMS dubbing takes place only at normal playback speed.
8 Press RMS/START or Il on deck B to start
dubbing.
RMS/START
ed
Deck B enters recording pause mode while deck
A searches for the selection to be played. When
playback starts on deck A, dubbing automatically
starts on deck B. This is preceded by the
recording of a 10-second blank on the tape in
deck B if you begin dubbing right after:
*you insert the cassette into the deck.
*you fastwind the tape by pressing << (or >> )
allowing the deck to stop automatically when the
tape reaches the end.
1 Insert cassettes into both tape decks.
2 While the tape is stopped, press RMS/
START.
3 Press [> or <J to select the front or back
. . To stop RMS dubbing
side of the tape, and << or P> to specif
hae sel ice e sik Press the ll button on deck B. RMS dubbing stops and the
unit returns to RMS mode.
4 Press SET to program a selection. =
5 Repeat steps 3 and 4 to program other
selections.
6 Press NORMAL to change the unit to
dubbing standby mode.
7 Select the side of the tape in deck B to be
dubbed.
To dub on the front side, press [> .
To dub on the reverse side, press <I] .
You can press O to make a blank space of four
seconds or more on the tape in deck B before the
start of RMS dubbing. For details, see page 15.