Sony TCM-929 - Getting Started; Preparing a Power Source

SECTION 1
This section is extracted from
instruction manual.
Recording
You can record right away with the built-in microphone.
Make sure that nothing is connected to the MIC jack.
TAPE COUNTER and
counter reset button
@ REC
mA STOP/
EJECT
Il PAUSE
1 Press the counter reset button to reset the TAPE COUNTER.
2 Press §& STOP/EJECT to open the cassette holder.
3 Insert a TYPE | (normal) tape with the side to start recording
facing upward, and close the cassette holder.
4 Press @ REC.
- PLAY is depressed automatically.
At the end of the tape, recording stops and the unit turns off
automatically.
To Press
Stop recording M+ STOP/EJECT
Pause recording ti PAUSE
Press the button again to resume recording.
Notes
* You cannot monitor the recording sound.
* For recording, we recommend the use of TYPE I (normal) tapes only. Do
not use TYPE II (CrO2) and TYPE IV (metal) tapes.
Recording with an External Microphone
MIC (PLUG IN POWER)
Connect a microphone of low impedance (not supplied) to the MIC
jack. The built-in microphone is automatically disconnected.
When using a plug-in-power system microphone, the power to the
microphone is supplied from this unit.
GENERAL
Playing a Tape
EAR
bP FF/CUE
<4 REW/REVIEW
p>
PLAY
ms
STOP/
EJECT
Ii PAUSE
VOL
(volume)
1 Press B& STOP/EJECT to open the cassette holder.
2 Insert a TYPE I (normal) tape with the side to start play facing
upward, and close the cassette holder.
3 Press B PLAY then adjust the volume.
At the end of the tape, playback stops and the unit turns off
automatically.
To Press or slide
m@@ STOP/EJECT
Stop playback/stop
fast forward or rewind
HE PAUSE
Press the button again to resume play.
Press and hold >» FF/CUE and release it at the
point you want
Press and hold << REW/REVIEW and release it
at the point you want
Pause playback
Search forward
during playback (CUE)
Search backward
during playback
(REVIEW)
Fast forward bP FF/CUE during stop
Rewind <4 REW/REVIEW during stop
At the end of the tape
All the locked buttons will be automatically released (Full auto
shut-offmechanism).
To listen with an earphone
Connect an earphone (not supplied) to the EAR jack of the unit.
The built-in speaker will be automatically disconnected.