2. Remove the HN-442 board.
(1) Disconnect the harness from the connector (CN002) on the HN-442 board.
(2) Release the harness from the edge saddle.
(3) Remove the nylon rivet and screw, then remove the HN-442 board.
(4) Release the edge saddle from the HN-442 board.
PSW3 x 6
HN-442 board
CN002
Nylon rivet
Harness
Edge saddle
Tip
When attaching the HN-442 board assembly, remove the front boards in the lower side to allow you to work easily.
Then, securely insert it into the connector on the motherboard while holding the connector on the HN-442 board.
3. Install the removed parts by reversing the steps of removal.
XVS-9000-C/XVS-8000-C/XVS-7000-C/XVS-6000-C
4-27
To Next Page
Loading...
