How to enable sMS-200 to the Gigabit Ethernet support
1. Hardware
A. Disassemble the front case
i. Unscrew 4points of Torx screws as like the image below.
B. Disassemble the LED board
i. Unscrew the black screw and separate the LED board from the front case.
C. Disassemble the rear case
i. Unscrew 4points of Torx screws as like the image below.
D. Remove ‘C670’ Chip Capacitor
i. Pull out the rear case very carefully to disassemble the main board from the body case.
1. Remove ‘C670’ by a soldering machine.
(If required, the power board can be disassembled.)
E. Assemble sMS-200 cases
i. Repeat to assemble sMS-200 cases in the reverse order.
To Next Page
